$ 49.99
The 5″ 14mm Male 45° Encore Color Showerhead Ash Catcher is a compact glass add-on made for smokers who are tired of scrubbing their main piece after every few bowls. It’s built for 45° 14mm female joints and uses a showerhead perc to trap ash and start filtration before smoke ever touches your bong. If you want smoother hits, less reclaim in your favorite tube, and a little color upgrade at the same time, this is the move.
This ash catcher is made for people who run their daily driver hard and hate when it starts to look swampy two days later. If you’re rocking a 14mm female, 45° joint water pipe and want cleaner, smoother hits without buying a whole new bong, this piece slides right into your setup. It’s also clutch if you like stacking function with other smoke shop products and slowly building your dream kit instead of swapping full pieces all the time.
Using the Encore Color Showerhead Ash Catcher is simple: treat it like an extra mini-chamber that lives between your bowl and your bong. The 14mm male joint on the ash catcher plugs into your bong’s 14mm female joint, then your bowl (or slide) sits in the joint on the ash catcher itself.
Add a small amount of water so the showerhead perc is just covered, then hit your piece as usual. As you pull, smoke drops into the ash catcher first, where ash, debris, and some of the heavier particles get trapped in the water and extra chamber. By the time the smoke moves into your main piece, it’s already been cooled and pre-filtered.
Set your setup on a sturdy, nonstick surface like a dab mat if you’re the type who occasionally bumps the table mid-sesh — it helps keep drips and reclaim off your furniture and makes cleanup easier.
After a few bowls or when the water starts looking rough, pull the ash catcher off, dump it, and rinse. It’s a lot less stressful to deal with than dragging your entire bong over the sink when you’re three bowls deep and just want things to work.
| Height | 5 inches (127mm) |
|---|---|
| Joint Size (Ash Catcher to Bong) | 14mm Male |
| Joint Angle | 45° |
| Perc Style | Showerhead perc |
| Material | Glass |
This Encore ash catcher is designed to plug directly into any water pipe with a 14mm female joint set at a 45° angle. That’s the standard angle you’ll see on a lot of beakers and smaller tubes — the joint comes off the neck at a diagonal instead of straight out.
Because it uses a 14mm male connection, it plays nice with most mid-sized glass pieces that already use 14mm hardware. If you’ve got multiple pieces and bowls, this makes it easy to swap the ash catcher around and see which tube it pairs with best. For storing your bowls, slides, and extra parts you’re not using, keeping a small stash of storage & packaging options around can help keep your gear organized instead of rolling around a drawer.
Let the ash catcher cool before cleaning, especially after heavy use. Dump the old water, rinse with warm water, and for heavier buildup, soak it in isopropyl alcohol, rinse thoroughly, and let it dry before using again. It’s usually easier to clean this often than to wait until it’s fully caked up — that’s also how you keep your main bong looking brand new.